TK1170 Bridge Assembly
This instruction set will show how to assemble the bridge provided with the TK1170
Tools Required:
3mm Hex Wrench
4mm Hex Wrench
Parts:
Start by attaching one of the TK uprights to the 510mm Extrusion using the M5 x 30mm Socket Head Bolt (4mm Hex Wrench).
Repeat this with the 3 Remaining TK uprights as shown below:
Place 4 of the M5 x 40 Shoulder bolts through the TKCP Cross Bar and insert into the mating holes on the TK upright:
Line up the custom Length Bridge Extrusion with the TK upright and fasten the M5 x 40 shoulder bolts using a 3mm Hex Wrench
Repeat on opposite side:
On opposite side of bridge, repeat the same process by placing 4 x M5 x 40 shoulder bolts through the TKCP cross bar and attach to back side of bridge using 3mm Hex Wrench: